Load Tray 2
This tray holds up to 500 sheets of 75 g/m
2
(20 lb) paper. If the paper is heavier, the tray does not
hold as many sheets. Do not overfill the tray.
The stack height for Tray 2 is 30 mm (1.18 in) for glossy paper and 40 mm (1.57 in) for short paper
(A5, A6, 4x6, and landscape).
CAUTION:
Do not print envelopes, labels, postcards, or unsupported sizes of paper from the Tray 2.
Print these types of paper only from Tray 1.
1.
Slide open the tray.
NOTE:
Do not open the tray while it is in
use.
2.
Adjust the paper-length and paper-width
guides by squeezing the adjustment latch and
sliding the guides to the size of the paper
being used.
84
Chapter 6 Paper and print media
ENWW
3.
Load paper into the tray face up. Check the
paper to verify the guides lightly touch the
stack, but do not bend it.
NOTE:
To prevent jams, do not overfill the
tray. Be sure the top of the stack is below the
tray full indicator.
NOTE:
If the tray is not adjusted correctly,
an error message might appear during
printing or the paper might jam.
4.
Slide the tray into the product.
5.
The control panel shows the tray’s paper type
and size. If the configuration is not correct,
follow the instructions on the control panel to
change the size or type.