Manually configure IPv6 TCP/IP parameters from the control panel
Use the control-panel Administration menus to manually set an IPv6 address.
1.
At the control panel, press the Home button.
2.
To enable manual configuration, open each of the following menus:
●
Administration
●
Network Settings
●
Jetdirect Menu
●
TCP/IP
●
IPv6 Settings
●
Address
●
Manual Settings
●
Enable
Select the On option, and then press the
OK
button.
3.
To configure the address, open each of the following menus:
●
Administration
●
Network Settings
●
Jetdirect Menu
●
TCP/IP
●
IPv6 Settings
●
Address
Use the numeric keypad, or press the up arrow or the down arrow to enter the address. Press
the
OK
button.
NOTE:
If you are using the arrow buttons, you must press the
OK
button after entering each
digit.
ENWW
Connect to a network with Windows
69